Swirly Christmas Card!

Supplies Needed:

• stamp set Stampin up (discontinued)

• infinity dies hero arts

• stitched squares dies sss

• crafters wand

• jewels pinkfresh studios

• Elegant Eggplant ink Stampin up

• Always Artichoke ink Stampin up

• paper trimmer Fisckar

• water droplets stencil gina k

• blending tool ranger inks

• finger dauber

• misti my sweet petunia

• 1/4" Black satin ribbon

• 1/2" Green ribbon American crafter

• foam tape

• 2.5" Xyron

• connect glue gina k

• Basic Black cardstock Stampin up

• Old Olive cardstock Stampin up

• Rich Razzleberry cardstock Stampin up

• Very Vanilla cardstock Stampin up

Thank you for joining my website and reading my blog! Cut card base 5.5" x 8.5" and score on the 4.25".

Tape the stencil over the top of the entire card front, then ink with Elegant Eggplant ink, using the foam blending tool. Cut one Black ribbon 11.25" and one 11.25" Green ribbon. Put ribbons through the Xyron one at a time. Layer the Black ribbon on top of the Green ribbon.

Place one end of the ribbons 1.25" from the fold of the card, wrap till the other end of the ribbon is adhered end to end with a slight overlap. Which will be under the framed stamped image.

Stamp the swirly Christmas tree on Very Vanilla cardstock with Elegant Eggplant and ink the edges with it as well using a blending foam tool.

Die-cut a stitched square out of Basic Black cardstock. Use a paper trimmer to cut a square of Rich Razzleberry cardstock. Adhere the swirly Christmas tree to the Rich Razzleberry cardstock square and add foam tape to the back. Then, apply it to the Black stitched square. Add adhesive to the back of the Black cardstock stitched square. Adhere 1/4" from the edge fold of the card front over the overlap of the ribbons.

Stamp the sentiment in Always Artichoke ink and ink with it as well with a foam dauber.

Die-cut a decorative oval to fit the sentiment. Die-cut a second oval bigger than the sentiment out of Old Olive cardstock to frame the sentiment.

Adhere the sentiment to the center of the Old Olive frame die-cut. Add foam tape so that it is flat against the swirly Christmas tree but equal height with the foam tape as it is placed in the lower right. Add connect glue dots on the swirly Christmas tree stamped image, and the sentiment as well, placing the jewels on the dots of glue.

Thank you for joining my website and reading my blog! Thank you again and see you on Friday.