Sunny Earrings
- melanie patton

- Sep 17, 2021
- 2 min read
Supplies needed:

Thank you for joining my blog! Start with a headpin, place in siam Swarovski, heishe bead, iridescent small Swarovski. Then crimp 1/16" use graduated loop tool to hold at the top. Then with plyers fold-over top and put the long end in the end loop of the five loop earring link wrap the long wire around the crimped section twice cut wire and use plyers to tightly wrap. Do steps a total of four times, placing one in each of the outside loops of the five loop earring links.
Start with a headpin, place large amber Swarovski crystal, heishe bead, small iridescent Swarovski. Then crimp 1/16" up from the beads, use graduated loop tool fold-over the top, and place wire in the second loop of the earring link. Do steps a total of four times, placing in the second loop from the ends of the five loop earring link.
Start with an eye loop headpin place small iridescent Swarovski, heishe bead, siam Swarovski. Then crimp 1/16" from beads, add teardrop bead and flatten wire against the edges of the teardrop bead wrap wire twice. Open the eye loop place through the center of the five loop earring link. Do a total of two and place in the center hole of the five loop earring link. Closing the eye loop back after it is added in the center loop of the earring link. Start with an eye loop headpin, place heishe, large iridescent Swarovski crystal, heishe. Then crimp 1/16" from heishe fold over and place the wire through the top loop of the earring link wrap wire twice.
Open the eye loop and place through the hole at the bottom of the leverback ear wire earrings do this a total of twice. Trim the twelve wires; if you haven't already done so.

Thank you for visiting my website and viewing my blog! Thank you again and see you on Friday!
















Comments