Reindeer Christmas Wreath!

Supplies Needed:

• metal painted reindeer

• styrofoam 11.7" diameter wreath

• 2.5" ribbon Robert Stanley

• poinsettia red

• poinsettia white

• holly leafed berries

• floral pins

• 2" mesh net copper-gold

• 5' red burlap

• scissors

• wirecutters

• needlenose plyers

• floral wire

Thank you for joining my website and reading my blog!

Using floral pins attach the red burlap, begin wrapping the wreath, and pin with floral pins when the wrap overlaps.

Floral pin the mesh net copper-gold wrap leaving a 1.5" space between the wraps until it overlaps.

Begin cutting poinsettias to short-length, holly leafed berries.

Place it less than halfway up the right side of the wreath. Then position the holly leaf berries, just under that position poinsettias two white, one red, & one white each staggered and slightly below coming down to the bottom center of each of the blooms above.

Place the metal reindeer into the foam wreath securely.

Do the loops of 2.5"wide ribbon to create the bow and wire the ribbon in the center securely, twist the wire, then wrap the wire around the wreath centered at the bottom of the wreath twist, secure, and trim wires.

Begin positioning the poinsettias white, red, and white staggering up closely on the left side of the bow. Bring the holly leafy berries closely down into the top left poinsettia to finish floral placement. Begin positioning the loops of the bow to make it a full bow.

Thank you for joining my website and reading my blog! Thank you again and see you on Friday!